An integral part of modern RF/microwave circuit design is circuit simulation and evaluation in which scattering parameters (S-parameters) for each element of a system are utilized to pre- dict the overall small signal performance as the elements are cascaded to form the entire system. The value and effectiveness of these evaluations are directly related to the accuracy of the S-parameters for ...
The IEEE 802.3ba amendment that will add 40 Gb/s and 100 Gb/s rates to the Ethernet standard is nearing completion, scheduled for publication in mid 2010. The draft currently specifies supportable distances of 100 meters on OM3 fiber and 150 meters on OM4 fiber for both rates. The common distances for both rates are the result of using inverse multiplexing over parallel fibers, wherein the ...
Automated Test Equipment (ATE) is a computer controlled device that is utilized to quickly test electronic components and assemblies. In the past, custom designed controllers or relay logic were used. An ATE system can be as simple as a Digital Multimeter (DMM) connected to a computer where data from the DMM is acquired, analyzed and stored. An ATE system can range from this simple example all ...
Company descriptions and contact
information are quoted
from the company's website or other promotional information. JAZ'D is not responsible for
the accuracy
of this information. Unless specifically noted, JAZ'D is not sponsored by, affiliated with
or otherwise
connected with any of the listed companies.
